Filter
Top Products
29
AUTO SETUP
PREPARATION
English
Warnings after auto setup
Press j / i to display detailed information about individual warnings.
•If the ERROR or WARNING screens appears, check the cause of the problem, then perform the auto setup procedure again.
•If warning W-1 appears, corrections are made, but they may not be optimal.
•If warning W-2 or W-3 appears, no corrections are made.
•If error E-10 occurs repeatedly, please contact a qualified YAMAHA service center.
Warning message Cause Remedy
W-1:OUT OF PHASE
Speaker polarity is not correct. This message
may appear depending on the speakers even
when the speakers are connected correctly.
•Check the speaker connections for proper polarity
(+ / –).
W-2:OVER 24m
The distance between the speaker and the
listening position is 24 m or more.
•Move the speaker closer to the listening position.
•Check the speaker connections for proper polarity
(+ / –).
W-3:LEVEL ERROR
The difference of volume level among speakers
is excessive. (No level correction is made.)
•Readjust the speaker installation so that all speakers
are set in locations with similar conditions.
•Check the speaker connections for proper polarity
(+ / –).
•Use speakers of similar quality and efficiency.