Filter
Top Products
22
Operation
This section explains how to operate the CRW8824SX drive after you have
installed it.
Loading a Disc
12
1 Press the Eject button on the CRW8824SX drive’s front panel.
2 Place the disc onto the tray with its label or printing facing upward.
3 Press the Eject button to close the tray.
n When a disc is loaded, the ON/DISC LED is lit up in orange first, then changes to
green. For more details, refer to page 30.
n Do not push or pull the tray using excessive force. Doing so can damage the drive
or the disc. Instead, always use the Eject button to open or close the tray.
Ejecting the Disc
12
1 Press the Eject button on the CRW8824SX drive’s front panel.
2 Remove the disc from the tray.
3 Press the Eject button to close the tray.
n It may not be possible to eject the disc tray while a disc is being read or in other
situations, depending on the SCSI command.
n Only remove the disc after the disc tray has opened fully. Otherwise, you risk
damaging the drive or the disc.