Filter
Top Products
Preparing the CRW3200E Drive
19
Analog connection
Connect one end of the included audio cable (the end with one connector)
to the analog audio output jack on the rear panel of the CRW3200E drive.
Be sure that the connector is in the correct direction prior to connecting it.
There are two types of connectors at the other end of the audio cable.
Select the one that fits the sound card: Vertical connector (PH) and
Horizontal connector (MPC).
Check the direction of the connector vertically and horizontally prior to
connecting it to the sound card. (Only use one of the two connectors, and
leave the other free.)
• Some sound cards have more than one audio input jack, including those
which do not support the specification of the CRW3200E drive.
• If you cannot hear playback audio from the speakers, refer to the
documentation that comes with the sound card.
Note
Analog audio
output jack
Ground (G)
Right channel (R)
Vertical connector (PH)
Audio cable
(included)
Horizontal
connector
(MPC)
Sound card
Audio input
jack
Left channel (L)