Filter
Top Products
Preparing the CRW3200E Drive
13
The setting methods for most IDE devices are as follows.
• Hard drive: Change the setting with the jumper switch on the circuit board on
the rear panel or the hard drive bottom panel. You have to set the cable select
(CSEL) on some hard drives.
• CD-ROMs, etc.: Change the setting with the jumper switch on the rear panel.
• When you use the IDE device as a master, connect the device to the connector at
the end of the IDE cable, or when you use the device as a slave, connect the
device to the middle of the cable.
• When you connect two IDE devices to one IDE cable, assign each as master or
slave respectively. The CRW3200E drive is set at slave by default.
Note