Filter
Top Products
18
• IDE devices supporting Ultra ATA/66 or Ultra ATA/100 do not operate
with the included 40-pin IDE cable. Prepare proper IDE cables for those
IDE devices.
• You can use an IDE cable that supports Ultra ATA/66 to connect to the
CRW3200E drive.
• Use an IDE cable no longer than 45.7 cm (18 in.).
• When two IDE devices are connected to one IDE cable, be sure to assign
each as master/slave respectively.
4
Connect an audio cable if necessary.
The sound card of the computer enables you to listen to audio CDs played
back on the CRW3200E drive. There are two methods to connect the
CRW3200E drive and the sound card: analog connection and digital
connection.
Audio CD playback
• Audio is available from the headphones or speakers connected to the
headphone jack on the front panel of the CRW3200E drive (this is
convenient for the computer without a sound card). In such a case,
connecting an audio cable is not required.
• An audio cable is not required to extract an image file from an audio
CD since data is transferred via the IDE cable.
• If the CRW3200E drive is installed as an additional drive and the CD-
ROM drive or DVD-ROM drive is already connected to the sound card,
Yamaha recommends that audio CDs be played back by the existing
drive.
Note
Continued on next page