Filter
Top Products
■ Formatting the HDD
If you install a new HDD, you need to format the HDD before
using with this unit.
1. Connect the AC power cable to the wall outlet and
turn on the power of this unit.
“Format Start?” appears on the display.
2. Press w/d.
“Format Really” appears on the display.
3. Press w/d.
“Push PLAY KEY” appears on the display.
4. Press w/d.
“Wait” flashes on the display. After a few seconds, this unit
starts formatting of the HDD. It takes approximately 15
seconds to complete formatting.
5. When formatting has been completed, “Format OK”
appears on the display. Then the display returns to
the one when the power of this unit was turned on.
Note
You do not need to format the HDD when using a HDD formatted
with this unit. When using a HDD formatted with another
CDR-HD1500 or other device, follow “Formatting the HDD (HDD
Format” (P.72) of “CDR-HD1500 Owner’s Manual”.
■ Recommended HDDs
We have checked the compatibility with CDR-HD1500 for the
following model (as of March, 2005):
• Seagate Baraccuda 7200.7 Series/ST3160021A (160GB)
(Company and product names are trademarks of their respective
company.)
For additional information on HDDs, see your local YAMAHA
authorized dealer.
4. Tighten the four fixing screws.
5. Push the HDD tray and connect the IDE cable and the
power cable.
• Make sure that the terminals and connectors are in the correct
direction, and connect the cables securely.
• Static electricity can damage the HDD. Be careful not to
touch the terminal pins and the circuit board.
• Do not apply excessive force on the HDD tray.
6. Close the HDD slot door and tighten the two fixing
screws on the HDD slot door.
IDE cable
Power cable
Fixing screws
English
■ Required specifications of the HDD
Interface.................................................................... IDE/ATA type
Data Transfer Mode........................................ PIO mode 0 to 4 and
Multi-word DMA mode 0 to 2 compatible
Size ............................................................................. 3.5-inch type
Capacity...................................................................... 20 to 400GB
■ Installation procedures
Before installation
•Turn off the power of this unit and unplug the AC power
cable from the wall outlet.
• Disconnect all the connections.
• Set the HDD to SLAVE (see description below).
MASTER or SLAVE setting on the HDD
It is necessary to set the HDD to MASTER or SLAVE when
connecting the HDD to the component you plan to use. This
unit is designed to operate HDD when it is set to SLAVE.
Usually, setting procedure is written on the HDD itself.
INSTALLING THE HDD
This product does not have a built-in hard disk drive (HDD) depending on the sales location. Please purchase a commercially available HDD
for internal use and install it on this unit correctly, referring to the instruction below.
1. Loosen the two fixing screws on the HDD slot door
and open the HDD slot door.
2. Pull out the HDD tray.
• Be careful not to hook the IDE cable and the power cable
over the HDD tray.
• Do not apply the excessive force on the HDD tray.
3. Place the HDD on the HDD tray.
• HDD is a very sensitive device. Be careful not to give any
shock to it.
Fixing screws
Fixing screws
(Screws are on the opposite side)
The HDD is set to slave by setting no plastic shunt at any
position of the jumper switch.
CDR-HD1500
HDD Installation Manual
Example: When setting the ST3160021A model
UAB
©2005 All Right Reserved.
Printed in Malaysia WF51710
(English)
HDDinstallation_UAB.p65 3/23/05, 6:33 PM1