Filter
Top Products
Chapter 2 - Installing the Yamaha CDR400At Drive
7
♦
Terminator setting
The terminator setting indicates whether or not this device is the last
connected SCSI device.
Terminator ON
(with a jumper)
— Use this setting if the CDR400At is the last device in the internal
SCSI daisy-chain.
Terminator OFF
(without a jumper)
— Use this setting if devices other than the CDR400At are in the inter-
nal SCSI daisy-chain and the CDR400At is not the last device.
♦
Block size setting
Block size ON
(with a jumper)
— Block Size is set to 512Byte/sector. This function is valid only for
workstations, such as those that run UNIX.
Block size OFF
(without a jumper)
—
Normally, use this setting.
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Terminator ON (default) Terminator OFF
* Use jumper connectors to short the locations shown in black.
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
Block size ON Block size OFF (default)
* Use jumper connectors to short the locations shown in black.