Filter
Top Products
E-35
English
RECORDING COMPACT DISCS
To record programmed tracks from one or
more discs
1 Select the CD position with the INPUT SELECTOR
control, watching the display, and load a disc (or discs) on
the disc table.
2 Follow steps 3–6 on page 33.
3 Press the PROG button.
* “PROGRAM” and “P-01” light up on the display, and all
track numbers on the selected disc begin flashing.
4 If necessary, select a desired disc by pressing the DISC
SKIP button.
5 Select the desired track number by pressing the track
number input buttons.
6 Repeat steps 4 and 5 to program more selections for the
side A of the tape. You can select the same track again.
* Pressing the TIME button displays the total remaining
time on the side of the tape for about 1 second, and
then it is replaced by the display of the next playback
order.
* If “ERR” appears on the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side A of the tape.
However, at this time, if any other track number is
flashing continuously on the display, you can program
it instead of the unprogrammable one.
7 After you finish the programming for the side A, press the
TAPE button.
* “Pu” appears on the display, then you can begin
programming for side B.
8 Repeat steps 4 and 5 to program selections for the side B
of the tape. You can select the same track again.
* If “ERR” appears on the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side B of the tape.
However, at this time, if any other track number is
flashing continuously on the display, you can program
it instead of the unprogrammable one.
9 Press the EDIT button. (“EDIT” appears on the display.)
The recording automatically starts.
Notes on tape-editing
•
If programs are made selecting tracks from more than one
disc, during recording, the PLAYXCHANGE button on the
CD player is disabled.
•
To check, cancel or correct program data, refer to page
16.
•
The maximum number of tracks that can be programmed
is 20.
•
This function can be used to program up to track number
20. If the disc has more than 20 tracks, track number 20
and thereafter will not be programmed.
Receiver
CD Player
Display information during programming
12345
CD
678
67890
12345
TIME
PROG
TAPE EDIT +10
ABCDE
REPEAT
RANDOM
STOP
PLAY/PAUSE OPEN/CLOSE
MODE
DISC SKIP
TUNER
DECK
A/B
PLAY STOP PLAY
TAPE
INPUT
REC/PAUSE
EFFECT LEVEL
SP/PHONES
MODE DSS
PROGRAM
A
2345 678910
11 12
1
REMAIN
PROGRAM
A
2345 678910
11 12
1
1
91
3
7
4
5
9
1
Selected
disc
Side of
the tape
Next playback order
Selected track
number
Total remaining time on
the side of the tape
Programmed track numbers light up
and unprogrammed ones flash.
TIME
1
TIME