Filter
Top Products
Installation Manual
XMD076A
XMD076A-3 Information is subject to the 15
Rev C, 06/22/06 restrictions on the title page
H E A D S U P T E C H N O L O G I E S
• With the XMC050 powered, press the "receiver select" button on the remote
(top right button).
• Enter 4881 for password, then enter 88.
• The display will show “Receiver ID Search”. XMC050 is now searching for
available receivers that are in range of the communication link (25 feet).
• When a receiver is found, the display will change to “Receiver ID Found” and
list the ID number of the receiver. Note: If multiple receivers are active, all of
the receiver ID’s will be listed. It is recommended to have only one receiver
active at a time to avoid confusion.
• Once the ID is determined, press the “receiver select” key again and type in
the number then proceed at Step 9 below.
9. Verify the remote display is showing “Connecting toXX” where XX is the “Receiver
ID” noted in Section 2.2 above. Allow at least 30-seconds for the initial connection
link to establish. Ignore the connection retry message displayed on the controller
during this time. Once this initial connection is made, further connections establish in
a few secondser up the XMC050 controller and set the “Receiver ID” as required.
10. If the connection fails to establish after 1-minute, try the following:
• Move the controller closer to the XMD076A
• Evaluate the location of the XMD076A and determine if an extension is
required. Refer to Section 2.3.3.1(7) above.
• Verify the XMD076A is still powered. Check circuit breaker, connectors, etc.
• Verify the charge indicator on the controller display shows a good charge.
Replace batteries as required.
11. Activate the audio equipment being fed by the XMD076A and adjust the volume
using the XMC050 controller as needed.
12. Change the XM channel to zero, “0”. The controller display should read “RADIO ID,
SW VER” and verify the 8-digit code matches the “Satellite Radio ID” noted in
Section 2.2 above.
NOTE:
At power-up, the XMD076A defaults to mute mode and will only output audio
when connected to the XMC050 wireless controller.