Filter
Top Products
Model MRC88m / MRAUDIO8x8m Page: 73
© 2009 Xantech Corporation
Source 1 will automatically be selected and by adding a “PLAY” command for a CD player to the
sequence, Zone 1 will always default to CD when turned ON. Pressing the “POWER” button again
will turn the zone “OFF”. (Be sure to set the PLAY command for the proper Source Emitter Output.
i.e. Right-click on command in Macro Command List and select Source 1 output)
9. Repeat for all zones and commands as required.
NOTE: Remember: As in the example above, to make commands accessible no matter which source is
selected, you will need to PUNCH the command (Zone Level).
Command Name Command Description Parameter 1 Parameter 2
Zone Power Command Discrete Power ON or OFF Zone (1-8) (9-16) PwrState (On, Off)
Zone Toggle Power Command Power Toggle Command Zone (1-8) (9-16) N/A
Zone Volume Command Set Volume to preset level Zone (1-8) (9-16) VolLevel (0 – 63)
Zone Volume Step Up Command Increase Volume Setting Zone (1-8) (9-16) N/A
Zone Volume Step Down Command Lower Volume Stetting Zone (1-8) (9-16) N/A
Zone Balance Level Command Set Balance to Preset Setting Zone (1-8) (9-16) BalLevel (-15-15)
Zone Balance Step Up Command Step Balance towards Rt. CH Zone (1-8) (9-16) N/A
Zone Balance Step Down Command Step Balance towards Lt. CH Zone (1-8) (9-16) N/A
Zone Treble Level Command Set Treble to Preset Setting Zone (1-8) (9-16) TrebLevel (-14dB-14dB)
Zone Treble Step Up Command Increase Treble Setting Zone (1-8) (9-16) N/A
Zone Treble Step Down Command Decrease Treble Setting Zone (1-8) (9-16) N/A
Zone Bass Level Command Set Bass to Preset Setting Zone (1-8) (9-16) BassLevel (-14dB-14dB)
Zone Bass Step Up Command Increase Bass Setting Zone (1-8) (9-16) N/A
Zone Bass Step Down Command Decrease Bass Setting Zone (1-8) (9-16) N/A
Zone Source Select Command Select Source for Zone Zone (1-8) (9-16) Source (1-8)
Zone Mute State Command Discrete Mute ON or OFF Zone (1-8) (9-16) MuteState (On, Off)
Zone Mute Toggle Command Mute Toggle Command Zone (1-8) (9-16) N/A
Zone Restore Balance Command Restore Balance to Center Zone (1-8) (9-16) N/A
Zone Restore Treble Command Restore Treble to Flat Zone (1-8) (9-16) N/A
Zone Restore Bass Command Restore Bass to Flat Zone (1-8) (9-16) N/A
Zone Start Z Adjust Command Enter ‘Zone Adjust’ Mode Zone (1-8) (9-16) N/A
Zone Set Max V Command Set Maximum Zone Volume Zone (1-8) (9-16) N/A
Zone Adjust Done Command Exit ‘Zone Adjust’ Mode Zone (1-8) (9-16) N/A
Zone Start Trim Adjust Command Set Source Input Trim Setting Zone (1-8) (9-16) N/A
Turn Off All Zones Command Power All Zones OFF Zone (1-8) (9-16) N/A
Set Max On V Command Set Maximum ON Volume Setting N/A N/A
Table 2 – Internal Amplifier Commands
ZONE EXPANSION (CONNECTING MULTIPLE MRC88M CONTROLLERS)
Two MRC88m Controllers can be used to expand the number of zones in a MRC88m system to SIXTEEN. The
two MRC88m System Controllers interface via their Expansion port located on the rear of each Controller
[Figure 3-(30)].