Filter
Top Products
The Receiving section also shows an input meter to indicate the signal level
returning from your EQ device, back into the channel.
C
ALIBRATION SECTION – The Headroom slider and the In and Out meters are on
the right side of the Q-Capture. These not only indicate that signal is being
received, but can also help to adjust the Headroom fader of the Transmitting
section. This is to insure optimal dynamic range and to avoid clipping in the
analog device. Please see the Calibrating section on page 11 for more
information.
If you find that you are not getting a signal, there can be multiple reasons for this.
All reasons are fairly straightforward and are related to routing and live input
monitoring. Please follow the set-up step by step directions on page 13, then
consult our Troubleshooting section or EQ sampling loop checklist and diagram if
you encounter problems.
Waves Q-Clone Manual
6