Filter
Top Products
Once the test-signal returns from the device, it is analyzed and loaded into the Q-
Clone component as an impulse-response. This happens several times per
second so that the EQ-settings of the device are well tracked by the cloned EQ.
As long as the Q-Clone is in ‘Capture’ mode, it keeps on tracking the EQ-settings
of the device. When the Q-Clone enters 'Hold' mode (accomplished by clicking
the Hold button) the very last settings are frozen.
All EQ settings are stored within sessions and can be stored as presets. The
presets can be shared across different sessions or different tracks within the
same session.
WHICH EQ HARDWARE DEVICES ARE SUPPORTED TO WORK WITH THE Q-
C
LONE?
1. Any “working condition” EQ device with analog/digital I/O.
2. Any analog channels strip with EQ section built in.
3. Not a combination of EQ with compressor or any other non linear
processor.
The plug-in components
Waves Q-Clone Manual
4