Filter
Top Products
TO LISTEN TO YOUR RECORDING
1. When you have finished recording stop the tape by pressing the “ST/EJ” key.
2. Rewind the tape by pressing the “REW” key until the tape stops at the desired location.
3. Select the “CASSETTE” button located below the CDG player to switch to cassette mode.
Note: This button should be set to CDG when recording from CDG to cassette.
4. Start the tape playback by pressing the “PLAY” key on the cassette deck.
5. Adjust the master volume control to the desired listening level. (See ”IMPORTANT INFORMATION” on page 5 )
Reminder: If you set the tape counter to zero before you start recording you can more easily keep track of you location on the tape.
OTHER PARTS OF THE BRAVO
RF MODULATOR
To accommodate those televisions which do not have RCA connectors The Bravo is supplied with an RF modulator.
VOLTAGE SELECT
This is used to select the voltage according to the country. In Europe select 220-224v, in USA select 110v.
VIDEO SYSTEM (NTSC/PAL)
This is used to select the video system according to country. In Europe select PAL, in USA select NTSC.
AC OUTLET
The AC outlet can be used to connect an additional component up to 200W maximum.
FUSE:
IMPORTANT! IF THE FUSE BLOWS OUT IT IS AN IMPORTANT INDICATION THERE MAY BE A SHORT SOMEWHERE IN THE
SYSTEM. DO NOT REPLACE THE FUSE! TAKE YOUR BRAVO TO AN AUTHORIZED REPAIR FACILITY. REPLACING THE FUSE
COULD POSSIBLY CAUSE ADDITIONAL DAMAGE THAT MAY NOT BE COVERED BY THE WARRANTY.
listen to your recording...
OTHER PARTS OF THE BRAVO
7