Filter
Top Products
Unpacking the CDG-X3 Mark II
Carefully remove the CDG-X3 Mark II player from its carton before discarding the packaging materials. If it should become necessary to
return the unit for any reason the original packaging materials are best suited for transporting the unit to minimize any potential damage.
IMPORTANT NOTE!: YOU WILL NEED TO CONNECT THIS UNIT TO AN AMPLIFICATION SOURCE, WITH SPEAKERS
CONNECTED TO THE AMPLIFIER.
BE SURE YOU HAVE THE PARTS AND COMPONENTS INCLUDED WITH THE CDG-X3 Mark II.
Thank you for purchasing the CDG-X3 Mark II. At VocoPro we care about product quality and customer
satisfaction. We know the CDG-X3 Mark II will provide years of quality enjoyment and reliable music
entertainment for you when used properly.
BEFORE YOU START
PLEASE READ CAREFULLY BEFORE USING YOU NEW CDG X-3 MARK II
CONNECTING A TELEVISION MONITOR
If you will be connecting the CDG-X3 Mark II to a television monitor use the RCA video
connector wire included. On the back of the player, locate the RCA connector jack labeled
“VIDEO OUTPUT”, it is color coded in yellow. Connect either end of the RCA connector wire
to the “VIDEO OUTPUT” jack and the other end to your television monitor. There should be an
RCA connector jack, just like the one on the back of the player, labeled video input. Connecting
this wire will enable your television monitor to display the graphics that are encoded on CDG
Karaoke discs. NOTE: If your television does not have an RCA type connector you may use a
VCR or an RF Modulator (not included) to connect your monitor. (See “Connection Diagram”
and “Trouble Shooting Guide” for options.)
2
SUPPLYING POWER TO THE CDG-X3 Mark II
IMPORTANT! Be sure all your components i.e., amplifier, TV monitor, etc.., are
connected to the CDG-X3 Mark II BEFORE connecting to a power source and
supplying power to the unit. Be sure to use caution when plugging in any
electrical appliance. The CDG-X3 Mark II comes with it’s own standard wall
outlet power cord. It is attached to the back of the CDG-X3 Mark II player unit.
Plug the power cord into any wall outlet or surge protector.
1 CDG-X3 Mark II
CD/CDG & Cassette Player
1 Remote Control
1 RCA cable for video hookup
CONNECTING A MICROPHONE
1. Using a microphone cable, designed for use with most Karaoke
products, connect a microphone to the end of the cable with the
“XLR” connector (see diagram).
2. Connect the end of the cable with the ¼” connector into either
of the ¼” jacks on the front of the CDG-X3 Mark II amplifier player.
QUICK START
¼” jack
IMPORTANT! Before connecting a microphone, be sure the power is off or the volume is turned
all the way down. When the microphone is plugged in and the unit is on do not point the
microphone toward the speakers or leave an unattended microphone too close to the speakers
when the volume is up. This can create a loud squeal called “feedback” and could possibly
damage your speakers.
“XLR”
connector