Filter
Top Products
Version 1/19/2009 17
www.VIZIO.com
Chapter 4
Chapter 4Chapter 4
Chapter 4
Sett
SettSett
Setting Up
ing Up ing Up
ing Up
HD Sound Bar System
HD Sound Bar SystemHD Sound Bar System
HD Sound Bar System/W
/W/W
/Wireless
irelessireless
ireless
S
SS
Sub
ubub
ub-
--
-W
WW
Woofer Setup
oofer Setupoofer Setup
oofer Setup
and
andand
and
P
PP
Pairing
airingairing
airing
The HD Sound Bar System operates in unison with the Wireless Sub-Woofer. They
come already paired from the factory. Please follow the procedure below if pairing the
units is needed:
Figure 1 - Power and Input connections - HD Sound Bar System
1. Connect an Optical (SPDIF) cable from the Optical Output on the source device to the OPTICAL
input; or connect one end of the left and right channel audio cables to AUDIO-IN-1 or AUDIO-IN-2
on the back of the HD Sound Bar System, and the other end to the Audio Output of the signal
source. The Inputs are shown in the figure 1 above.
2. Before connecting the AC cord to an outlet, connect the HD Sound Bar
System power adapter DC connector (Fig 1).
3. Before connecting the AC cord to an outlet, connect the Sub-Woofer
power adapter DC connector (Fig 2)
4. Connect the AC cords of the power adapter to suitable AC outlet.
5. Switch the HD Sound Bar System power to ON by either using the power
button on the top of the HD Sound Bar System or the power button in the
remote control.
6. Having both units turned on, press the LINK button on the back of the
Sub-Woofer, then press and hold the Input button on the HD Sound Bar
System for at least 5 seconds to have both units paired up and ready to
use. The LED on the front of the subwoofer will flash quickly. Once
pairing is requested,
the device will attempt for up to 30 seconds and then end the pairing mode.
7.
Select the desired input by pressing the Input button on the Sound Bar or the
Remote. The default input is Analog 2 when the Sound Bar is first plugged in.
Refer to Page 8 for additional information.
The following is a description of the Sub-Woofer LED blink codes:
On continuously: A link is active.
Flashing slowly: A link cannot be established.
Flashing quickly: The wireless device attempting to pair.
Figure 2
Power
connection
and Link
Button on
Sub-Woofer