Filter
Top Products
23
8.4. Delay Screen
Each output has an independent delay time control. This can be adjusted in 2.6µs
steps and in 1ms steps giving complete control over driver time alignment.
Input delay (base delay) is adjustable in 1ms steps only.
To adjust the delay settings:
Select relevant channel by pressing the channel ‘GAIN’ button.
Use the ‘BACK’ and ‘NEXT’ keys to select the delay screen.
Use the ‘FREQ’ control for coarse control. (1mS steps)
Use the ‘Q’ control for fine control. (2.6µS steps)
(N.B. To show delay in distance (mm or feet) rather than time, go into the ‘system
sub-menu’, select ’DelayTime/Distance’, select ‘Metres’ or ‘Feet’.)
8.5. Polarity Screen
Each output has an independent polarity screen. This gives the flexibility to reverse
the phase of individual outputs (rotate by 180°).
(N.B. When the outputs are ganged, the polarity screens remain individual.)
To adjust the polarity:
Select relevant channel by pressing the channel ‘GAIN’ button.
Use the ‘BACK’ and ‘NEXT’ keys to select the polarity screen.
Use the ‘GAIN’ control to toggle between + and -.
OP1 Low
Polarity = [ + ]
OP1 Low
Delay = 1.003mS