Filter
Top Products
57
C-IN01 to 12: NONE (default), VOLUP (volume up), VOLDOWN (volume down), MUTE,
POWER, EMG-MUTE (Cut-off by Emergency control), BGMEND*
ZM-IN01 to 12: NONE, VOLUP, VOLDOWN, BGMEND*
* Only in the 1-channel or 2-channel output operation
Setting Range
(C4) Control input function setting
C- IN01– N
O
N
E
Sets the functions to be assigned to the control input terminals or control buttons of the ZM-9001 or ZM-9002.
C- IN01 EVENT N
O
NE
(C3) Event assignment display (Only in the normal matrix operation)
When the displayed control input (C-IN01 in this example) is set to Trigger in the Event setting, the Event
number is displayed.
If the control input is not set to Trigger, the NONE indication is displayed.
Assigning a function to the control input terminal preset to "Event-Trigger" cancels the "Event-Trigger"
function, being replaced with the new function.
Set the volume level (dB) to increase or decrease.
(When the control input function is set to VOLUP:) (When the control input function is set to VOLDOWN:)
C- IN01– V
O
LU
P
C- IN01– V
O
LD
O
W
N
(C5)
Assign the volume-up or volume-down function to the control input.
Closing the control input terminal increases or decreases the volume of the set input or output channel.
Assigning a function to the control input terminal or ZM-9001/9002's control button overwrites the previously
set function on it if there is.
C- IN01–V
O
LUP IN
1
Channel number selection (VOLUP)
C- IN01–V
O
LD
W
N IN
1
Channel number selection (VOLDOWN)
(C6)
Using the Input channel or Output channel selection key, select the channel number for which you want to
change the volume.
One control input can change one input or output channel volume.
You can change the sound volume for a channel even with the channel off, but not adjust it while monitoring
the sound.
0.5 – 10.0 dB (default: 0.5)
Setting Range
IN1 – 8 (default: IN1)
Setting Range
Volume increasing level setting (VOLUP)
C- IN01–V
O
LUP 05
.
Volume decreasing level setting (VOLDOWN)
C- IN01–V
O
L
D
W
N
05
.
(C7)