Filter
Top Products
50
(B10) Trigger setting (when Event classification is set to BGM END)
EVENT01TR I
G
C- IN01
Activating the selected Event terminates all Events for Priority-8 inputs.
Set the control input that activates the Event termination.
Assigning a function to the control input terminal or ZM-9001/9002's control button overwrites the previously
set function on it if there is.
C-IN01 – 04 (C-IN01 – 12 when C-001T is used), ZM-IN01 – 12* (default: C-IN01)
* Selectable only when the Remote controller type (p. 62-C26) is set to ZM-9001 or ZM-9002.
Setting Range
EVENT01 C
O
U
T
01
(B9) Interlock output terminal setting (when Event classification is set to ROUTE)
Set the control output terminals 1 – 4 (1 – 12 when the C-001T is used) which are closed in synchronization
with the Event's activation.
Assigning a function to these terminals overwrites the previously set functions on them if there are.
EVENT01 SYNC
O
N
(B8) Interlock output control ON/OFF setting (when Event classification is set to ROUTE)
Set whether or not to close the control output terminal in synchronization with the Event's activation.
• ON: Control output terminal is closed when the Event is activated. (The terminal is continuously closed
during Event activation.)
• OFF: Control output does not interlock with the Event's activation.
ON, OFF (default)
Setting Range
COUT01 – 04,
C-OUT01 – 12 when C-001T is used
(default: COUT01)
Note: When the interlock output control ON/OFF setting is ON.
Setting Range
(B7) Busy input terminal setting
(when Event classification is set to ROUTE, Trigger to C-IN or ZM-IN,
and Event other than BGM Events is set)
BUSY– I N N
O
N
E
Select the control input terminal to receive Busy signal.
Selecting the terminal overwrites the previously set function on it if there is.
Once broadcast is activated by means of a pulse trigger, a signal is needed to terminate the broadcast.
A busy signal is used for this purpose. It works in the way that the busy signal (make contact) is kept being fed
to the control input terminal during broadcast but cut at the end of broadcast.
Thus, the end of broadcast is defined by using a busy signal.
NONE (default), C-IN01 – 04 (C-IN01 – 12 when C-001T is used)
Setting Range