Filter
Top Products
Data Input/Output
3- 254
CSA7000 Series, TDS7000 Series, & TDS6000 Series Instruments User Manual
Use the procedure that follows to save a waveform or waveforms to a reference
location, the instrument hard disk, CD-RW disk, a floppy disk, or third party
storage device.
Overview To save a waveform Control elements and resources
Prerequisites 1. The instrument must be powered up.
2. Make sure the waveform to be saved exists; that is, your
source must be a channel, an active math waveform, or
an active reference. Display the waveform with the
setup in which you want to save it.
For help in setup and acquiring waveforms, check the
references at right.
H See Powering On the Instrument on page 1--9.
H See page 3--34 for acquisition setup.
H See page 3--71 for trigger setup.
Display the
reference
control window
3. From the toolbar, touch Refs and select the Ref 1 to Ref
4 tab of the reference in which you want to save the
waveform.
Select the
waveform to
save
4. Select the Ch, Math, or Ref tab of the waveform that
you want to save, and then touch the number of the
channel, math, or reference waveform that you want to
save.
To Save Your Waveform