Technics WX-H3050 Headphones User Manual


 
18
The headset ID is not registered in the center module of the tar-
get.
Register ID in the center module of the target.
The battery is almost exhausted.
Recharge the battery.
(Refer to the operating instructions of the battery charger.)
The center module may be turned off.
Turn on the power switch of the center module. (Refer to the
operating instructions of the center module.) If no remedy
exists, consult your dealer for repairs.
The headset ID is not registered in the center module of the tar-
get.
Register ID in the center module of the target.
The vehicle detector may be malfunctioning because the detec-
tor is not plugged into the center module, no power is supplied,
or the detecting function is out of order.
Check that the vehicle detector is plugged in and has power.
(Refer to the operating instructions of the center module.)
If no remedy exists, consult your dealer for repairs.
Radio waves cannot reach the area.
Remove any metal obstacles blocking radio waves.
Check that the Telephone Indicator of the Center Module is not
turned ON.
If the indicator is turned ON, the Optional Function Button [R] is
turned ON.
Press the Optional Function Button [R] again and check that
the Telephone Indicator is turned OFF.
Reference
pages
Cause/solution
17
17
8
Symptom
The power indicator blinks red.
The power indicator lights red
and a constant beep is heard in
the headphone.
Cannot communicate with other
store personnel or the customer
at the menu board.
Cannot hear or talk to the cus-
tomer, but communications with
the store personnel are OK.
Cannot "page" or "talk" in certain
areas.
The battery is exhausted.
The battery is not inserted correctly.
Recharge the battery.
Position the battery properly.
9
Cannot turn on the headset.
Troubleshooting
Talk or page operation is
impossible from the All-in-One
Headset set in the manager
mode.