Filter
Top Products
13
■ Manager Mode (Only one head-
set)
Complete ID Registration, to do this setting.
The headset set to the Manager mode has following func-
tionality.
• The manager can interrupt store personnel's TALK or
PAGE at any time by monopolizing one channel by prior-
ity.
• The Manager hears audio from POS alone.
1. Hold down the power button for two seconds or more to
turn off the headset.
2. While holding R and T1 simultaneously, press the power
button to turn on the headset.
The headset enters manager setting mode where the
indicators and buttons have different functions than in
normal operation. You can hear "Connecting center
module A" and power indicator is an alternate blinking of
red and green. Also the Lane indicator A is blinking yel-
low.
When you want to register the manager in another cen-
ter module in a double-drive-thru environment, while
holding R and T2 simultaneously, press the power but-
ton to turn on the headset. You can hear "Connecting
center module B" and the power indicator blinks red and
green. Also the Lane indicator B blinks green.
3. If manager mode setting is successful, you can hear
"Manager" and the power indicator blinks green.
■ Canceling the Manager Mode
1. Turn off the power of All-in-One Headset that has been
set for the manager mode.
2. When LANE A is set in the manager mode, keep press-
ing the R and T1 buttons simultaneously and start up the
power of All-in-One Headset.
When LANE B is set in the manager mode, keep press-
ing the R and T2 buttons simultaneously and start up the
power of All-in-One Headset.
The power indicator then blinks reciprocally in red and
green. A message of "Connecting Center Module A (or
B)" is heard from the All-in-One Headset speaker.
3. When canceling of the manager mode is complete, reci-
procal blinking of the power indicator turns to continu-
ous lighting in green.
Keep holding
down (LANE A)
Keep holding
down (LANE B)
Power button
Power button
Keep holding
down (LANE A)
Keep holding
down (LANE B)