Filter
Top Products
16
Caution: Setup of this product should only be performed by
qualified service personnel or system installers.
■ Opening the Switch
Compartment
1. Press the power button for 2 seconds or more to turn off
the headset.
2. Unscrew the screw and open the switch compartment.
3. Set the switches as described below.
4. After finishing the setup, replace the cover.
5. Turn on the headset.
■ DIP Switch Setup
An eight-bit DIP switch is provided for system setups. The
initial setting is marked with an asterisk *.
Note: Be sure to turn off the headset in Step 1. Otherwise,
the DIP Switch will not be activated until you turn the
power off and on again.
1. Press the power button for 2 seconds or more to turn off
the headset. headset.
2. Set the switches as follows.
SW#1: This switch selects Auto Talk Lock ON/OFF
ON: Auto Talk Lock ON
OFF: Auto Talk Lock OFF
SW#2: This switch selects the target lane for "SW#1:
Auto Talk Lock".
ON: Lane B
OFF: Lane A
SW#3: This switch selects Direct Lane Select Mode or
Normal.
ON: Direct Lane Select Mode
When double-drive-thru, the T1 button is for lane
A, the T2 button is for lane B.
OFF: Normal
For double-drive-thru, the T2 button is A/B Lane
Selection.
SW#4: This switch selects Talk Lock or Press-To-Talk
ON: Talk Lock
OFF: PTT (Press-To-Talk)
SW#5: This switch selects Page Lock or Press-To-Page.
ON: PAGE Lock
OFF: PTP (Press-To-Page)
SW#6, SW#7: This switch selects language of Voice
Prompt.
Setup Procedures
1
SW#
2
3
4
5
6
7
8
Auto TALK Lock ON/OFF
Function
Voice Prompt Language Select
Voice Prompt Language Select
ON
ON
OFF*
OFF
Auto TALK Lock LANE B A*
T2 Button Setting Direct Lane Select Normal*
Talk Lock/Press-To-Talk TALK Lock PTT*
Page Lock/Press-To-Page PAGE Lock PTP*
RF Power Reduce Power Full Power*
1
2
3
4
5
6
7
8
Initial Setting
ON
OFF
SW#6
OFF*
OFF
ON
ON
OFF*
ON
OFF
ON
English
Spanish
French
Voice Prompt OFF
SW#7 Language