Filter
Top Products
30
Troubleshooting
If the power supply is interrupted for 14 days or longer, all the
settings kept in memory (such as preset stations and timer settings)
will be erased.
It will take more than 3 days after plugging the power cord into
the outlet to charge enough electricity for the memory backup
function.
If you want to manually initialize the settings, hold down
the SOURCE button and play/pause (y/J) for more than 4
seconds in standby mode.
The unit will be turned on, and all the settings are reset to the
default settings.
In case of trouble with the unit, please take the time to look through
this chart and see if you can solve the problem yourself before you
call your dealer or TEAC service center.
Amplifier
No power.
e Check the connection to the AC power supply.
No sound from speakers.
e Check the connection to the speakers.
e Adjust the volume.
e Select proper source.
e Pull out the headphones plug from PHONES jack.
e If muting is on, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV set or similar appliances. Install the
unit apart from them, or turn them off.
Clock goes wrong.
e The clock setting will not be saved when the POWER turns off.
Do not turn off the POWER switch on the front panel.
Remote Control Unit
Remote control unit does not work.
e If the batteries are exhausted, change the batteries.
e Use remote control unit within the range (5 m) and point at the
front panel.
e Clear obstacles between the remote control unit and the main
unit.
e If a fluorescent light is near the unit, turn it off.
Tuner
Cannot listen to any station, or signal is too weak.
e Tune in the station properly.
e If a TV set is near the unit, turn it off.
e Install the antenna again after locating the best reception
position.
e An external antenna is recommended.
Though the broadcast is stereo, it sounds monaural.
e Press the FM MODE button.
iPod Player
Will not play.
e Remove the iPod from the USB jack, wait a few seconds, and
insert it again.
e Software update may solve the problem. Visit the Apple website
and download the latest iPod software.
Cannot operate the iPod.
e Make sure the HOLD switch of the iPod is not set to HOLD.
MP3/WMA
There is no sound even if the play/pause button (y/J) is
pressed.
e Check if there are MP3 or WMA files on the USB.
e Non-playable file formats (e.g MPEG 1 LAYER 2 file) cannot be
played.
Restoring factory settings