Filter
Top Products
7
ENGLISH
CD, TAPE MONITOR, VIDEO/AUX jacks
Analog 2-channel audio signal is input or output from these
jacks. Connect the component with commercially-available
RCA cables.
Make sure to connect:
white plug q
white jack (L: left channel)
red plug q
red jack (R: right channel)
PHONO jacks/SIGNAL GND terminal
Connect the turntable’s RCA pin cords to PHONO jacks.
Make sure to connect:
white plug q
white jack (L: left channel)
red plug q
red jack (R: right channel)
Connect the turntable’s ground cord to SIGNAL GND
terminal.
RESET switch
In the following cases, function buttons may not work
properly.
• When the system is damaged by electrical shock.
• When the power is irregular or has electrical noises.
In these cases, press the RESET switch once or twice with a
pencil or a ball-point pen lightly.
All the settings kept in memory (such as preset stations) will
be erased.
AC Outlet (Unswitched)
This outlet is active only when the unit is on or standby.
When the power switch of the main unit is off, the outlet is
inactive.
Caution:
Make sure that the total power consumption of all
equipment connected to the outlet does not exceed 100
watts or 1A.
Power cord (AC)
Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging the
power cord. Never pull or yank on the power cord.
F
E
D
C
B
Speaker Connections
Caution:
To avoid damaging the speakers with a sudden high-level
signal, be sure to switch the power off before connecting
the speakers.
<
Check the impedance of your speakers. Connect speaker
with an impedance of 8 ohms or more.
< The black speaker terminals are - (negative).
Generally, the + side of the speaker cable is marked to make
it distinguishable from the - side of the cable. Connect this
marked side to the + terminal and the unmarked side to the
black - terminal.
<
Prepare the speaker cables for connection by stripping off
approximately 10 mm or less of the outer insulation.
(Removing too much insulation may lead to a short circuit if
the bared wires should come in contact with each other.)
Twist the strands of the stripped wires tightly together:
Caution:
The metal portions of the two separate wires should not
touch or an electrical short can occur. Shorted wires can
create a fire hazard or induce a failure in your equipment.
How to connect
1.Turn the terminal cap counterclockwise to loosen it. The
speaker terminal caps cannot be fully removed from the base.
2.Insert the wire into the terminal fully and turn the terminal
cap clockwise to securely connect it .
Make sure none of the wire insulation is under the terminal,
only the bare, stripped wire.
3.Make sure it is fastened firmly by pulling the cable lightly.
A