Filter
Top Products
5
ENGLISH
AM Indoor Loop Antenna
The high-performance AM loop antenna provided with this
unit is sufficient for good reception in most areas.
To stand the loop antenna on a surface, fix the claw to the
slot in the antenna base.
Connect the loop antenna’s wires to the AM antenna
terminals.
How to connect:
Press the lever, insert the end of the cord,
then release the lever. Make sure it is
fastened securely by pulling the cord lightly.
Make sure only the bare, stripped wire is
inserted in the jack and that no plastic
insulation is preventing contact between the
antenna wire and terminal.
Place the antenna on a shelf or hang it on a window frame,
etc., in the direction which gives the best reception. Keep all
other wires such as power cords, speaker wires or
interconnect wires as far away as possible from the antenna.
AM Outdoor Antenna
If the AM loop antenna provided does not deliver sufficient
reception (often due to being too far from the transmitter or
in a concrete building, etc.), it may be necessary to use an
outdoor AM antenna.
Use either a high quality commercial AM antenna or, if not
available, an insulated wire more than 5 m (15 feet) long,
strip one end, and connect this to the terminal as shown.
The antenna wire should be strung outdoors or indoors near
a window. For better reception, connect the GND terminal to
a reliable ground.
Note:
Even when using an outdoor AM antenna, do not disconnect
the AM loop antenna.
AM Outdoor Antenna
AM Loop Antenna:
Connect the black wire
to the left jack (GND)
and the white wire to
the right jack.