Filter
Top Products
BEFORE USE
Read this before operation
1. Choose the installation location of your unit
carefully. Avoid placing it in direct sunlight or
close to a source of heat. Also avoid locations
subject to vibrations and excessive dust, cold or
moisture.
2. Do not cover the ventilation holes. Make sure
there is enough space above and beside this unit
(about 4 inches). Do not place a CD player or
other equipment on top of this unit.
3. Do not open the cabinet as this might result in
damage to the circuitry or electrical shock. If a
foreign object falls into the unit, contact your
dealer.
4. When removing the power plug from the wall
outlet, always pull directly on the plug, never on
the cord.
5. Do not attempt to clean the unit with chemical
solvents as this might damage the finish. Use a
clean, damp cloth only.
6. Keep this manual in a safe place for future
reference.
Back-up Memory Function
This is the function that preserves the preset
memory and most-recent memory function. In the
event of a power failure, or if the power cord of this
unit is disconnected from the electric outlet, the
back-up memory will preserve the preset memory
and most-recent memory functions for approximately
1 week. If the power supply is interrupted for 7 days
or longer, the memory settings will be erased.
When to use RESET switch
1. When this system is subjected to an electric
shock.
2. When the power is irregular.
In this case, try the following:
Switch the POWER on, press the RESET button on
the front panel for more than 3 seconds.
Note: If the RESET button is pressed for more than
3 seconds, all the memory will be erased.
Before Connection
Caution
- Disconnect all equipment from the power source
before making any connections.
- Read instructions of each component you intend to
use with this unit.
- Be sure to insert each plug securely. To prevent
hum and noise, do not bundle the connection cords
with power cord or speaker cord.
Speaker Connections
Caution:
- To avoid damaging the speakers with a sudden
high-level signal, be sure to switch the power off
before connecting the speakers.
- Check the impedance of your speakers. Connect
speaker with an impedance of 6 ohms or more.
- The amplifier’s red speaker terminals are the +
(positive) terminals and the black terminals are the –
(negative) terminals.
- The + side of the speaker cable is marked to make
it distinguishable from the – side of the cable.
Connect this marked side to the red + terminals and
the unmarked side is the black terminal.
- Prepare the speaker cords for connection by
stripping off approximately 10 mm or less (no more
as this could cause a short-circuit) of the outer
insulation.
- Twist the wires tightly together so that they are not
straggly.
How to connect
Red: positive (+)
Black: negative (-)
1. Press down the lever at the antenna terminal.
2. Insert the exposed wire into the terminal hole
3. Release the lever.
4