Filter
Top Products
6
Before Use
What’s in the box
Confirm that the standard accessories are included.
Remote control unit (RC-1283) x 1
Batteries (AAA) for remote control unit x 2
Stereo RCA pin cable x 2
Owner’s manual (this document) x 1
< Keep this manual in a safe place for future reference.
Warranty card x 1
CAUTION
< Do not move the unit during CD playback.
During CD playback, the disc rotates at high speed. Do not lift or
move the unit during playback. Doing so might damage the disc
or the unit.
< The voltage supplied to the unit should match the voltage that
is printed on the rear panel. If you are in any doubt regarding this
matter, consult an electrician.
< Do not open the cabinet as this might result in damage to the
circuitry or electrical shock. If a foreign object should get into the
unit, contact your dealer or service company.
< When removing the power plug from the wall outlet, always pull
directly on the plug, never yank on the cord.
< Always remove the disc before relocating or moving this unit.
Moving the unit with a disc inside it could cause malfunction.
Placement of the unit
< Choose the location where you install the unit carefully. Avoid
placing it in direct sunlight or close to a source of heat. You should
also avoid locations that are subject to vibrations or exposed to
excessive dust, heat, cold or moisture.
< As the unit may become warm during operation, always leave
sufficient space around it for ventilation.
< Do not place the unit on an amplifier, a receiver or any other device
that generates heat.
< When the unit is turned on, if a TV is turned on nearby lines might
appear on the TV screen depending on the frequency of the TV
broadcast. This is not a malfunction of the unit or the TV. If you see
such lines, move the unit and the TV further apart.
Beware of condensation
When the unit is moved from a cold to a warm place, or used after a
sudden temperature change, there is a danger of condensation; vapor
in the air could condense on the internal mechanism, making correct
operation impossible. To prevent this, or if this occurs, leave the unit
turned on for one or two hours. Then the unit will stabilize at the
temperature of its surroundings.
Maintenance
If the surface of the unit gets dirty, wipe it with a soft cloth or
use diluted mild liquid soap. Allow the surface of the unit to dry
completely before using.
For safety, disconnect the power cord from the outlet before
cleaning.
< Never spray liquid directly on this unit.
< Do not use thinner or alcohol as they could damage the surface of
the unit.
Cleaning and demagnetizing the cassette deck
Cleaning
A dirty head can cause poor sound quality or the sound to skip.
Dirt on the tape tracking roller might catch the tape.
Clean the head, pinch roller, and capstan with a cotton applicator
dampened with a commercially available cleaning solution about
every ten hours of use.
Capstan
Playback/
recording head
Erasing head
Pinch roller
Demagnetizing
When the head is magnetized, it increases noise and hinders the
transmission of high notes.
If these problems occur, demagnetize the head using a commercially
available head eraser.
< Do not put a cassette tape in the cassette holder of the unit until
the cleaning solution on the head dries.