Filter
Top Products
TASCAM CD-RW5000
23
6 - Specifications
6.1 Audio specifications
6.2 I/O specifications
Recording time 74 minutes (with 74-minute disc)
CD type Playback of CD-DA (Red Book),
CD-R and CD-RW
Recording on CD-R and
CD-RW
a
a. Brands of disc that are recommended for used
with the CD-RW5000 are the Taiyo Yuden and
Ricoh brands.
Input sampling frequency
32 kHz — 48 kHz
b
b. The CD-RW5000 incorporates an automatic
sampling frequency convertor to convert input
to 44.1 kHz. However, the following should be
noted. The sampling frequency convertor is
activated when the sampling frequency falls
outside 44.1 kHz (to a tolerance of
±
100ppm).
If the input signal suffers from jitter, and
“drifts” around the nominal 44.1 kHz fre-
quency, the sampling frequency convertor will
keep engaging and disengaging, producing
audible noise in the recording.
Recording sampling
frequency
44.1 kHz
Recording resolution 16-bit linear
Frequency response 20 Hz to 20,000 Hz (
±
0.5 dB
playback,
±
1 dB recording)
S/N ratio >98 dB (playback), >90 dB
(recording)
Dynamic range >95 dB (playback), >90 dB
(recording)
Total harmonic distortion
(1 kHz @ FS – 1.1 dB at
recording)
<0.008% (playback), < 0.012%
recording)
Channel separation >90 dB (playback), >86 dB
(recording) (1kHz @ FS)
Wow and flutter Unmeasurable (<0.001%)
Analog inputs (balanced
XLR-3-31 type)
Nominal input level +4dBu
(FS=–16 dB)
Maximum input level +20 dBu
Input impedance 10 k
Ω
Analog inputs (unbal-
anced RCA)
Nominal input level –10dBV
(FS=–16 dB)
Maximum input level +6 dBV
(2Vrms)
Input impedance 10 k
Ω
Analog outputs (balanced
XLR-3-32 type)
Nominal output level +4dBu
(FS=–16 dBu)
Maximum output level +20 dBu
All level measurements made
with trimmer set to maximum
value
Output impedance 75
Ω
Trimmers provide up to 12 dB of
attenuation
Analog outputs (unbal-
anced RCA)
Nominal output level –10 dBV
Maximum output level +6 dBV
(2 Vrms)
Output impedance 200
Ω
Headphone 1/4-inch
stereo jack
(2 x 32 mW into 32
Ω)
Digital output (optical
TOSLINK)
IEC60958 format (Type II)
a
a. IEC-60958 Type I (AES3-1992) is a standard
for broadcasting studios (professional). It can-
not be used for connecting consumer products.
IEC-60958 Type II (SPDIF) is a standard for
consumer products.
Digital output (unbalanced
RCA)
IEC60958 format (Type II)
Digital input (balanced
XLR-3-31 type)
AES3-1992 (Type I)
a
or
IEC60958 format (Type II)
Digital input (unbalanced
RCA)
AES3-1992 (Type I) or
IEC60958 format (Type II)
Digital input (optical
TOSLINK)
AES3-1992 (Type I) or
IEC60958 format (Type II)
Parallel I/O port 15-pin ’D’-sub connector
REMOTE CONTROL
3.5 mm mini-jack
For use with supplied
RC-RW5000 remote control unit
only