Filter
Top Products
34 TASCAM CD-A550/CD-A750
5 – Playing Back CDs
The call point is erased after any of the following
operations.
The power is turned OFF
•
The disc tray is opened
•
The playback mode is changed
•
The folder playback function ON/OFF setting is
•
changed
The folder is changed
•
If you press the CALL key when no call point has
•
been set, “No Call Pt!” appears on the main display.
The call function cannot be used during random
•
playback mode.
Resume playback
Turn the resume playback function ON to allow playback
to restart from the position where playback was last stopped
(resume point).
When the resume playback function is ON, RESUME appears
on the display.
1 When in standard display mode, press the MENU
key on the main unit or the remote control to enter
menu mode.
2 Use the –/+ keys on the main unit or the remote con-
trol to show “RESUME?” on the main display, and
press the ENTER key on the main unit or the remote
control.
3 Use the –/+ keys on the main unit or the remote con-
trol to select “ON” or “OFF” (default value).
4 Press the ENTER key to return to the standard dis-
play.
The resume point ON/OFF setting is retained even if
•
the power is turned OFF.
The resume point is erased after any of the following
•
operations.
The disc tray is opened
–
The folder playback function ON/OFF setting is
–
changed
The folder is changed
–
The playback mode is changed
–
EOM function
Turn the EOM (End Of Message) function ON to have the
unit start blinking the playback time display when the audio
CD reaches the remaining playback time set in advance. In
addition, the CD-A750 model can send an EOM tally signal
with this information from its
CONTROL I/O PARALLEL
jack, and this tally signal can be used to light an external
lamp, for example. Use the menu to set the EOM function.
(See “Using the menu” on page 17 for details about how to
use the menu.)
1 When in standard display mode, press the MENU
key on the main unit or the remote control to enter
menu mode.
2 Use the –/+ keys on the main unit or the remote con-
trol to show “
EOM DISP?
” on the main display,
and press the ENTER key.
3 Use the –/+ keys to choose one of the following set-
tings.
Options: OFF (default value), 5sec, 10sec, 15sec, 20sec,
25sec, 30sec, 35sec
All the settings except for “OFF” turn the EOM function
ON and indicate the number of seconds before the end
of the track when the unit’s playback time starts to blink
on the display.
4 Press the ENTER key to return to the standard dis-
play.
This setting is retained even if the power is turned OFF.
How to use the tally signal (CD-A750 only)
1 Following the procedures above, use the menu to
set the EOM DISPLAY item to any setting besides
“OFF.”
2 Connect this unit to the device that is to receive the
EOM tally signal using the CONTROL I/O PARALLEL
jack. See “Using the parallel connector” on page 45
for information about the PARALLEL jack pin alloca-
tion.
3 Turn the power of this unit and the receiving device
ON.
4 Start playback of the CD in this unit. During play-
back, when the set track remaining time is reached
the EOM tally signal is output from the CONTROL I/
O PARALLEL jack.