Filter
Top Products
User's Manual
8
13. Speaker Level Outputs
This is the connection to the Sunre
HRSIW8 in-wall subwoofer. Use high-
quality Class-2 speaker wiring.
The red post is the positive output, and
connects to the positive (red) post of
the HRSIW8 subwoofer. The black post
is the negative, and connects to the
negative (black) post of the HRSIW8
subwoofer. The ve-way, gold-plated
posts can accept bare wire, pins, spade
terminals, and dual or single banana
connectors.
The amplier is designed to power
only the Sunre HRSIW8 in-wall
subwoofer. No other subwoofer
or speaker should be connected,
or this may lead to serious damage to
your equipment.
14. Voltage Select Switch
This switch allows the amplier to be
set to the local AC mains voltage, either
115 VAC or 230 VAC.
Always unplug the power cord and
all other connections, before mov-
ing this switch. Undo the two small
screws and remove the protec-
tive plate covering the switch. Set the
switch to the local AC mains voltage.
Replace the protective cover.
15. Line Fuse
The subwoofer is supplied with a con-
servative slow-blow type fuse to protect
the electronics.
Always unplug the power cord
before inspecting or changing
the fuse. Never use a fuse with a
larger current rating than shown
on the markings next to the fuseholder.
Use a small at screwdriver to pry out
the fuseholder and replace the fuse.
16. IEC Linecord socket
The amplier comes with a detachable
linecord which connects here.
US (120 VAC) MODEL: Connect the
linecord to the amplier before connect-
ing the other end to a 120 Volt, 60 Hz
AC outlet. The outlet must have a cir-
cuit rating of 8 amps or more (a typical
home circuit is rated at 15 amps).
Never plug the US (120 VAC)
Model amplier directly into 220-
240 Volts AC as this will cause
catastrophic circuit failure.
European (230 VAC) MODEL: Connect
the linecord to the amplier before con-
necting the other end to a 230 Volt, 50
Hz AC outlet. The outlet must have a
circuit rating of 4 amps or more.
HRSIW8AMP
1514 16
HRSIW8AMP
13