Filter
Top Products
38
GB
D:\NORM'S JOB\SONY HA\SO0109\STR-DH520\4263361111_GB\GB05BAS_STR-DH520-
U2.fm
masterpage: Left
STR-DH520
4-263-361-11(1)
1 Press the corresponding input
button which you want to check
the information.
2 Press AMP MENU, then press
DISPLAY repeatedly.
Each time you press the button, the
display changes cyclically as follows:
Index name of the input* t Selected
input t Sound field currently applied t
Volume level t Stream info**
When listening to FM and AM radio
Preset station name* t Frequency t
Sound field currently applied t Volume
level
When receiving RDS broadcasts
(Europe, Australia and Taiwan
models only)
Program Service name or preset station
name* t Frequency, band and preset
number t Sound field currently applied
t Volume level
* Index name appears only when you have
assigned one to the input or preset station
(page 37, 42). Index name does not appear
when only blank spaces have been entered,
or it is the same as the input name.
**Stream information may not be displayed.
Note
Character or marks may not be displayed for some
languages.
Recording using the
receiver
You can record from an audio/video
equipment using the receiver. Refer to the
operating instructions supplied with your
recording equipment.
1 Press the input button which
corresponds to the playback
equipment.
You can also use INPUT SELECTOR on
the receiver.
2 Prepare the playback
equipment for playing.
For example, insert the video tape you
want to copy into the VCR.
3 Prepare the recording
equipment.
Insert a blank video tape, etc. into the
recording equipment (VIDEO) for
recording.
4 Start recording on the
recording equipment, then start
the playback equipment.
Notes
•Some sources contain copyright protection to
prevent recording. In this case, you may not be able
to record from the source.
•Only analog signals are output from the analog
output jack (for recording).
•HDMI sound cannot be recorded.
•While only composite video signals are being
recorded, the auto standby function of the receiver
may start up and interrupt the recording. In this
case, set the “AUTO.STBY” to “STBY OFF”
(page 60).