Filter
Top Products
12
GB
D:\NORM'S JOB\SONY HA\SO0109\STR-DH520\4263361111_GB\GB03DES_STR-DH520-
U2.fm
masterpage: Left
STR-DH520
4-263-361-11(1)
To use the buttons printed in
pink
Hold down SHIFT (O), then press the button
printed in pink that you want to use.
Example: Hold down SHIFT (O), then press
ENT/MEM (C).
To control the receiver
B ?/1* (on/standby)
Turns the receiver on or sets it to standby mode.
Saving the power in standby mode
When “CTRL.HDMI” is set to “CTRL OFF”
(page 56).
C Input buttons**
Selects the equipment you want to use. When
you press any of the input buttons, the receiver
turns on. The buttons are assigned to control
Sony equipment.
Numeric buttons**
Hold down SHIFT (O), then press numeric
buttons to preset or tune to the preset stations.
ENT/MEM
Hold down SHIFT (O), then press ENT/MEM
to store a station during tuner operation.
D DIMMER
Adjusts the brightness of the display panel in 3
levels.
E INPUT MODE
Selects the input mode when the same
equipment is connected to both digital and
analog jacks.
2
Press
ENT/MEM
1
Hold down
SHIFT
F DISPLAY
Views information on the display panel.
I AMP MENU
Displays the menu to operate the receiver.
J
Press V/v/B /b to select the settings, then press
to enter/confirm the selection.
M TUNING +/–
Scans a station.
PRESET +/–
Selects preset stations.
D.TUNING
Enters direct tuning mode.
N SOUND FIELD +**/–
Selects a sound field.
O SHIFT
Changes the remote control button function to
activate the buttons printed in pink (page 12).
Q MASTER VOL +/– or +/–
Adjust the volume level of all speakers at the
same time.
R MUTING or
Turns off the sound temporarily.
Press the button again to restore the sound.
S RETURN/EXIT O
Returns to the previous menu.
W AUTO VOL
Adjusts the volume automatically depending on
the input signal or content from the connected
equipment (ADVANCED AUTO VOLUME
function).
This function is useful, for example, when the
sound of a commercial is louder than the TV
programs.
Notes
• Be sure to reduce the volume level before you
turn off this function.
• As this function is available only when Dolby
Digital, DTS or Linear PCM signals are input,
the sound may suddenly increase when you
switch to other formats.
• This function does not work in the following
cases.
– Linear PCM signals with a sampling
frequency of more than 48 kHz are being
received.
– Dolby Digital Plus, Dolby TrueHD, DTS
96/24, DTS-HD Master Audio, or DTS-HD
High Resolution Audio signals are being
received.
,
V/v/B/b