Filter
Top Products
36
GB
D:\NORM'S JOB\SONY HA\SO0109\STR-DH520\4263361111_GB\GB05BAS_STR-DH520-
U2.fm
masterpage: Left
STR-DH520
4-263-361-11(1)
4 Press V/v repeatedly to select
“AUTO xxx*”.
The test tone is output from each speaker
in sequence.
* xxx represent a speaker channel.
Note
Depending on the speaker pattern settings, test
tone may not be output from all speakers even
though you selected “AUTO xxx”.
5 Adjust the speaker levels.
Use the LEVEL menu (page 54) to adjust
the speakers to have the same sounding
test tone level for each speaker.
Tips
•
To adjust the level of all speakers at the same
time, press MASTER VOL +/– or
2
+/–. You
can also use MASTER VOLUME on the
receiver.
•The adjusted value are shown on the display
panel during adjustment.
6 Exit test tone.
Press any input buttons or select “OFF”
under step 4.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely.
• The speaker cords may have the short-circuit
problem.
When a test tone is output from
a different speaker than the
speaker indicator showed in the
display panel
The speaker pattern set up is incorrect. Make
sure that the speaker connections and the
pattern match correctly.
Playback
1
Turn on the connected
equipment.
2 Turn on the receiver.
3 Press the input button which
corresponds to the equipment
you want.
You can also use INPUT SELECTOR on
the receiver.
The selected input appears on the display
panel.
Note
When you press TUNER, “FM TUNER” or
“AM TUNER” appears for a while, and then
frequency appears on the display panel.
Basic Operations
Input
buttons
,
V/v/B/b
AMP
MENU
MASTER
VOL +/–/
2 +/–
MUTING/
SOUND
FIELD +/–