Filter
Top Products
43
GB
Getting Started
Note
Depending on the characteristics of the sub woofer
you are using, the setup distance value may be
further away from the actual position.
Using the receiver as a pre-
amplifier
You can use the auto calibration function when
you use the receiver as a pre-amplifier.
In this case, the distance value shown on the
display may differ from the actual distance
value. However, there will be no problems
even if you continue to use the receiver with
that value.
The auto calibration function allows you to
measure the following:
• Speaker connections
a)
• Polarity of speakers
• Speaker distance
b)
• Speaker size
b)
• Speaker level
• Frequency characteristics
c)
a) This receiver corrects signals by analog
downmix processing only for the center speaker
and sub woofer when the multi-channel input is
selected. The correction is invalid for other
speakers.
b) The measurement result is not utilized when the
multi-channel input is selected.
c) • DTS 96/24 signals are always played back as
48 kHz when you correct signals.
• The measurement result is not utilized in the
following cases.
–The multi-channel input is selected.
–“2ch Analog Direct” is being used.
–Input signals of which the sampling frequency
is more than 96 kHz are being received.
1 Make sure that the AMP button
is lit.
If it is not lit, or “GUI MODE” is not
displayed in the display window of the
receiver, follow the steps given in “7:
Operating the receiver using the GUI
(Graphical User Interface)” (page 37).
2 Press V/v repeatedly to select
“Settings,” then press or b.
The Settings menu list appears on the TV
screen.
3 Press V/v repeatedly to select
“Auto Calibration,” then press
or b.
4 Press V/v repeatedly to select
“Quick Setup,” then press .
5 Press V/v repeatedly and to
un-check the items you do not
want to measure.
• Speaker Distance
• Speaker Level
Performing auto calibration
2-7
1
continued