Filter
Top Products
123
GB
Additional Information
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure that the command modes of the
receiver and the remote are the same. If the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 36).
• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
Error messages
If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
PROTECTOR
Irregular current is output to the speakers, or
the upper panel of the receiver is covered
with something. The receiver will
automatically turn off after a few seconds.
Check the connection of the speakers and
turn on the power again.
For other messages, refer to “Message list after
auto calibration measurement” (page 47),
“XM Radio message list” (page 85), “SIRIUS
Satellite Radio message list” (page 85) and
“DIGITAL MEDIA PORT message list”
(page 90).
Reference sections for clearing
the memory
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
Rated Power Output at Stereo Mode
1) 2)
(8 ohms 20 Hz – 20 kHz,
THD 0.09%):
100 W + 100 W
Reference Power Output at Stereo Mode
(4 ohms 20 Hz – 20 kHz,
THD 0.15%):
85 W + 85 W
Reference Power Output
(8 ohms 1 kHz, THD 0.7%)
FRONT
2)
:
110 W + 110 W
CENTER
2)
: 110 W
SURROUND
2)
:
110 W + 110 W
SURROUND BACK
2)
:
110 W + 110 W
Reference Power Output
(4 ohms 1 kHz, THD 0.7%)
FRONT
2)
:
100 W + 100 W
CENTER
2)
: 100 W
SURROUND
2)
:
100 W + 100 W
SURROUND BACK
2)
:
100 W + 100 W
1)
Depending on the sound field settings and the
source, there may be no sound output.
2)
Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz
To clear See
All memorized settings page 35
continued