Filter
Top Products
masterpage:Left
lename[C:\Documents and
S
ettings\pc13\Desktop\JC060000_4253437131DE197_GB\4253437131\GB07ADD_STR-
D
E197-CEL.fm]
model name1[STR-DE197]
[4-253-437-13(1)]
26
GB
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Power Output
Models of area code U, CA
Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
125 W + 125 W
1)
Models of area code CEL, CEK
Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
100 W + 100 W
1)
1) Measured under the following conditions:
Frequency response
Inputs (Analog)
2) INPUT SHORT (with bass boost and tone
bypassed).
3) Weighted network, input level.
Outputs (Analog)
Bass Boost: +8 dB at 70 Hz
Tone: ±10 dB at 100 Hz and
10 kHz
FM tuner section
Tuning range 87.5 – 108.0 MHz
Antenna FM wire antenna
Antenna terminals 75 ohms, unbalanced
Intermediate frequency 10.7 MHz
Sensitivity
Mono: 18.3 dBf, 2.2 µV/75 ohms
Stereo: 38.3 dBf, 22.5 µV/75 ohms
Useable sensitivity 11.2 dBf, 1 µV/75 ohms
S/N
Mono: 76 dB
Stereo: 70 dB
Harmonic distortion at 1 kHz
Mono: 0.3%
Stereo: 0.5%
Separation 45 dB at 1 kHz
Frequency response 30 Hz – 15 kHz,
+0.5/–2 dB
Selectivity 60 dB at 400 kHz
AM tuner section
Tuning range
Models of area code U, CA
With 10-kHz tuning scale: 530 – 1,710 kHz
4)
With 9-kHz tuning scale: 531 – 1,710 kHz
4)
Models of area code CEL, CEK
With 9-kHz tuning scale: 531 – 1,602 kHz
Antenna Loop antenna
Intermediate frequency 450 kHz
Usable sensitivity 50 dB/m (at 1,000 kHz or
999 kHz)
S/N 54 dB (at 50 mV/m)
Harmonic distortion 0.5% (50 mV/m, 400 Hz)
Selectivity
At 9 kHz: 35 dB
At 10 kHz: 40 dB
4) You can change the AM tuning scale to 9 kHz or 10
kHz. After tuning in any AM station, turn off the
receiver. While holding down PRESET TUNING +,
press ?/1. All preset stations will be erased when
you change the tuning scale. To reset the scale to 10
kHz (or 9 kHz), repeat the procedure.
Specifications
Area code Power requirements
U, CA 120 V AC, 60 Hz
CEL, CEK 230 V AC, 50 Hz
CD, MD/TAPE,
VIDEO 1, 2
20 Hz – 50 kHz
+0/–0.5 dB (with bass
boost and tone bypassed)
CD, MD/TAPE,
VIDEO 1, 2
Sensitivity: 500 mV
Impedance: 50 kiloohms
S/N
2)
: 85 dB
(A, 500 mV
3)
)
MD/TAPE (OUT),
VIDEO 1 (AUDIO OUT)
Voltage: 500 mV
Impedance: 10 kiloohms
GB01COV_STR-DE197-CEL.book Page 26 Thursday, May 25, 2006 9:37 AM