Filter
Top Products
131
US
D:\NORM'S JOB\SONY HA\SO120031\STR-DA1800ES_PMRF
02\4428194122_USFR\US07ADD_STR-DA1800ES-CEL.fm
masterpage: Right
STR-DA1800ES
4-428-194-12(2)
Additional Information
• Press BLUETOOTH on the receiver to
connect to the last connected Bluetooth
device.
• Turn on the Bluetooth function of the
Bluetooth device.
• Establish a connection from the Bluetooth
device.
• The pairing registration information has
been erased. Perform the pairing operation
again (page 85).
• While connected to a Bluetooth device,
this receiver cannot be detected and a
connection cannot be established from
another Bluetooth device.
• Erase the pairing registration information
of a Bluetooth device (page 107) and
perform the pairing operation again.
The sound skips or fluctuates, or the
connection is lost.
• The receiver and the Bluetooth device are
too far apart.
• If there are obstacles between the receiver
and your Bluetooth device, remove or
avoid the obstacles.
• If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device, or a
microwave oven nearby, move them
away.
The sound of your Bluetooth device
cannot be heard on this receiver.
• Turn up the volume on your Bluetooth
device first, and then adjust the volume
using MASTER VOL + (or MASTER
VOLUME on the receiver).
Severe hum or noise
• If there are obstacles between the receiver
and your Bluetooth device, remove or
avoid the obstacles.
• If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device, or a
microwave oven nearby, move them
away.
• Turn down the volume of the connected
Bluetooth device.
The Control for HDMI function does not
work.
• Check the HDMI connection (page 28).
• Make sure “Ctrl for HDMI” is set to “ON”
in HDMI Settings menu.
• Make sure “Zone2 / OutB” is set to
“OutB” in HDMI Settings menu.
• Make sure “HDMI OUT” setting is set to
“HDMI A” (page 91).
• Make sure the connected equipment is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected equipment. Refer to the
operating instructions of the connected
equipment.
• If you unplug the HDMI cable or change
the connection, repeat the procedures of
“Preparing for the “BRAVIA” Sync”
(page 88).
• When “Ctrl for HDMI” is set to “OFF”,
the “BRAVIA” Sync does not work
properly, even if the equipment is
connected to the HDMI IN jack.
• The types and the number of equipment
which can be controlled by the
“BRAVIA” Sync are restricted in the
HDMI CEC standard as follows.
– Recording equipment (Blu-ray Disc
recorder, DVD recorder, etc.): up to 3
equipment
– Playback equipment (Blu-ray Disc
player, DVD player, etc.): up to 3
equipment
– Tuner-related equipment: up to 4
equipment
– AV receiver (audio system): up to 1
equipment
“BRAVIA” Sync (Control for
HDMI)