Filter
Top Products
127
US
D:\NORM'S JOB\SONY HA\SO120031\STR-DA1800ES_PMRF
02\4428194122_USFR\US07ADD_STR-DA1800ES-CEL.fm
masterpage: Right
STR-DA1800ES
4-428-194-12(2)
Additional Information
The receiver cannot connect to the
WPS via a wireless LAN connection.
• You cannot connect to a network using
WPS when your access point is set to
WEP. Set up your network after searching
the access point using the access point
scan.
An error message appears.
• Check the nature of the error. See
“Network features message list”
(page 82).
The receiver cannot connect to the
network.
• Check the network status. See “To check
the network information” (page 104), then
select “Connection” in step 2.
If “Connection Fail” appears, set up the
network connection again (page 70).
• When the system is connected through a
wireless network, move the receiver and
the wireless LAN router/access point
closer to each other and do the setup again.
• Check the settings of the wireless LAN
router/access point and do the setup again.
For details on the settings of the devices,
refer to the operating instructions of the
devices.
• Make sure that you use a wireless LAN
router/access point.
• Wireless networks are influenced by
electromagnetic radiation emitted by
microwave ovens and other devices. Move
the unit away from these devices.
• Make sure that the wireless LAN router/
access point is turned on.
Cannot control the receiver using the
Media Remote device.
• The receiver may take a long time to
connect to the network after you turn on
the receiver. Wait for a few moments, and
then try using the Media Remote again.
• Make sure “Network Standby” is set to
“On” in the Network Settings menu so that
you can use the Media Remote
immediately after you have turned on the
receiver.
Cannot select the Network Settings.
• Wait for a few moments after you turned
on the receiver, and then select the
Network Settings menu again.
The receiver cannot connect to the
network.
• Make sure the wireless LAN router/access
point is turned on.
• Make sure the server is turned on.
• The network settings on the receiver may
be incorrect. Check the network status.
See “To check the network information”
(page 104), then select “Connection” in
step 2.
If “Connection Fail” appears, set up the
network connection again (page 70).
• The server may be unstable. Restart it.
• Confirm that the receiver and the server
are connected to the wireless LAN router/
access point correctly.
• Confirm that the server has been set
correctly (page 70). Confirm that the
receiver has been registered to the server
and allows the music streaming from the
server.
• When the system is connected to the
wireless network, move the receiver and
the wireless LAN router/access point
closer to each other.
Network connection
Home Network
continued