Filter
Top Products
Additional Information
49
GB
Error messages
If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
DEC. EROR
Appears when the signal which the receiver cannot
decode (ex. DTS-CD) is input when “DEC.” is set to
“DEC. PCM”. Set to “DEC. AUTO”.
PROTECT
Irregular current is output from the speakers. Turn
off the receiver, check the speaker connection and
turn on the power again. If this problem persists,
turn off the receiver and consult your nearest Sony
dealer.
Reference sections for clearing
the memory
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel minimum
RMS power, with no more than 0.09% total harmonic
distortion from 250 milliwatts to rated output.
Amplifier section
POWER OUTPUT
STR-DA1000ES:
Rated Power Output at Stereo Mode
(8 ohms 20 Hz – 20 kHz, THD 0.09%) 100 W + 100 W
(4 ohms 20 Hz – 20 kHz, THD 0.09%) 80 W + 80 W
Reference Power Output
(8 ohms 20 Hz – 20 kHz, THD 0.09%)
FRONT
1)
: 100 W + 100 W
CENTER
1)
: 100 W
SURR
1)
: 100 W + 100 W
SURR BACK
1)
:
100 W + 100 W
(4 ohms 20 Hz – 20 kHz, THD 0.09%)
FRONT
1)
: 80 W + 80 W
CENTER
1)
: 80 W
SURR
1)
: 80 W + 80 W
SURR BACK
1)
:
80 W + 80 W
STR-DB790:
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%) 100 W + 100 W
2)
90 W + 90 W
3)
(4 ohms 1 kHz, THD 0.7%) 90 W + 90 W
2)
80 W + 80 W
3)
Reference Power Output
2)
(8 ohms 1 kHz, THD 0.7%)
FRONT
1)
: 100 W + 100 W
CENTER
1)
: 100 W
SURR
1)
: 100 W + 100 W
SURR BACK
1)
: 100 W
(4 ohms 1 kHz, THD 0.7%)
FRONT
1)
: 90 W + 90 W
CENTER
1)
: 90 W
SURR
1)
: 90 W + 90 W
SURR BACK
1)
: 90 W
(8 ohms 20 Hz – 20 kHz, THD 0.09%)
FRONT
1)
: 90 W + 90 W
CENTER
1)
: 90 W
SURR
1)
: 90 W + 90 W
SURR BACK
1)
: 90 W
(4 ohms 20 Hz – 20 kHz, THD 0.09%)
To clear See
All memorized settings page 19
Customized sound fields page 37
Specifications
continued