Filter
Top Products
Advanced Adjustments and Settings
39
GB
x SB XXXX
(Surround back decoding mode)
You can use the CUSTOMIZE menu to set the
surround back decoding mode (page 34).
For details on each decoding mode, see page 35.
• SB AUTO
• SB MTRX
•SB OFF
Note
This parameter is valid only in the A.F.D. mode
(page 31).
x S.F XXXX (Sound field link)
• S.F LINK
Lets you apply the last selected sound field to an
input whenever it is selected. For example, if you
select HALL for the CD/SACD input, then change to
a different input and return to CD/SACD, HALL will
automatically be applied again.
•S.F FIX
Sound field link is not activated.
x DEC. XXXX
(Digital audio input decoding priority)
Lets you specify the input mode for the digital signal
input to the DIGITAL IN jacks.
The initial setting is “DEC. AUTO” for VIDEO 3 and
TV/SAT, and “DEC. PCM” for DVD and MD/TAPE.
• DEC. AUTO
Automatically switches the input mode between
DTS, Dolby Digital, or PCM.
•DEC. PCM
PCM signals are given priority (to prevent the
interruption when playback starts). Even when other
signals are input, the sound is output. However, this
receiver cannot decode DTS-CD when set to “DEC.
PCM”. When set to “DEC. AUTO” and the sound
from the digital audio jacks (for CD, etc.) is
interrupted when playback starts, set to “DEC.
PCM”.
x D.PWR. XXXX
(Digital power management)
• D.PWR. OFF
Lets you turn off the power of the unnecessary digital
circuits automatically when outputting the analog
audio signals using the ANALOG DIRECT or
MULTI CH IN function. You can enjoy high quality
analog audio without the influence of digital circuits.
• D.PWR. ON
Lets you keep the power of digital circuits on. Select
if you do not like the time lag that occurs with the
“D.PWR. OFF” setting.
x PWR.S. XXX
(CONTROL A1: Power link)
• PWR.S. ON
The power link function is not activated, but you can
decrease the power consumption of the receiver
during standby mode.
• PWR.S. OFF
Lets you turn on the system automatically when the
component connected via CONTROL A1 cords
(page 45) is turned on.
x COAX-XXX
(Coaxial Input Assignment)
•DVD
Lets you assign the COAXIAL input jack to DVD
input.
•CD
Lets you assign the COAXIAL input jack to CD/
SACD
input.
x [DIMMER]
Lets you adjust the brightness of the display.
x NAME IN
(Naming preset stations and inputs)
Lets you set the name of preset stations and inputs
selected with INPUT SELECTOR. For details, see
“Naming preset stations and inputs” on page 42.
Advanced SP SETUP menu
parameters
When “MENU” is set to “MENU EXP.”, all of
the following parameters are displayed and
adjustable.
See page 20 for the SP SETUP menu
adjustments. Initial settings are underlined.
continued