Filter
Top Products
Getting Started
23
GB
Adjust the speaker levels and balance while
listening the test tone from your listening
position. Use the remote for the operation.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
1 Press ?/1 on the remote to turn on the
receiver.
2 Press TEST TONE on the remote.
“T.TONE” appears in the display and the
test tone is output from each speaker in
sequence.
3 Adjust the speaker level and balance
using the LEVEL menu so that the level
of the test tone sounds the same from
each speaker.
For details on the LEVEL menu settings,
see page 36.
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/– on the remote or
turn MASTER VOLUME –/+ on the receiver.
• You can also use –/+ on the receiver for the
adjustment.
4 Press TEST TONE again after
adjustment.
The test tone turns off.
To output the test tone only from
a specific speaker
Set “T.TONE” in the LEVEL menu to “FIX”
(page 36). The test tone is output only from the
selected speaker.
For more precise adjustment
You can output the test tone or sound source
from two adjacent speakers to adjust their
balance and level.
Set “MENU” in the CUSTOMIZE menu to
“MENU EXP.” (page 38). Then select the two
speakers you want to adjust using “P.NOISE” or
“P.AUDIO” in the LEVEL menu (page 41).
Note
The test tone cannot be used when ANALOG DIRECT
or MULTI CH IN function is used.
6: Adjusting the speaker
levels and balance
— TEST TONE