Filter
Top Products
26
GB
(Models of area code CEL, CEK only)
This function lets you store up to 30 FM and FM
RDS stations in alphabetical order without
redundancy. Additionally, it only stores the
stations with the clearest signals.
If you want to store FM or AM stations one by
one, see “Presetting radio stations”.
1 Press ?/1 to turn off the receiver.
2 Hold down MEMORY/ENTER and press
?/1 to turn the receiver back on.
“AUTO-BETICAL SELECT” appears in
the display and the receiver scans and stores
all the FM and FM RDS stations in the
broadcast area.
For RDS stations, the tuner first checks for
stations broadcasting the same program,
then stores only the one with the clearest
signal. The selected RDS stations are sorted
alphabetically by their Program Service
name, then assigned a 2-character preset
code. For more details on RDS, see
page 27.
Regular FM stations are assigned 2-
character preset codes and stored after the
RDS station.
When done, “FINISH” appears in the
display momentarily and the receiver
returns to the normal operation.
Notes
• Do not press any button on the receiver or supplied
remote during autobetical operation, except ?/1.
• If you move to another area, repeat this procedure to
store stations in your new area.
• For details on tuning the stored stations, see “Tuning
to preset stations”.
• If you move the antenna after storing stations with
this procedure, the stored settings may no longer be
valid. If this happens, repeat this procedure to store
the stations again.
You can preset up to 30 FM or AM stations.
Then you can easily tune in the stations you
often listen to.
Presetting radio stations
1 Rotate INPUT SELECTOR to select FM
or AM.
2 Tune in the station that you want to
preset using Automatic Tuning
(page 25) or Direct Tuning (page 25).
3 Press MEMORY/ENTER.
“MEMORY” appears in the display for a
few seconds. Do steps 4 to 5 before the
display goes out.
4 Press PRESET TUNING + or PRESET
TUNING – to select a preset number.
If you want to switch the memory page,
press SHIFT on the remote.
If “MEMORY” goes out before you select
the preset number, start again from step 3.
5 Press MEMORY/ENTER again.
The station is stored to the selected preset
number.
If “MEMORY” goes out before you press
MEMORY/ENTER, start again from step
3.
6 Repeat steps 2 to 5 to preset another
station.
Tuning to preset stations
1 Rotate INPUT SELECTOR to select FM
or AM.
2 Press PRESET TUNING + or PRESET
TUNING – repeatedly to select the
preset station you want.
Each time you press the button, you can
select the preset station as follows:
Storing FM stations
automatically
— AUTOBETICAL
Presetting radio stations
tA1yA2y...yA0yB1yB2y...yB0T
tC0y...yC2yC1T