Filter
Top Products
53
GB
Additional Information
No sound or only a very low-level sound is heard
from the rear speakers.
/ Make sure the sound field function is on (press
SOUND FIELD – MODE).
/ Select a sound field containing the word “cinema”
or “virtual” (see page 30~33).
/ Adjust the speaker volume (see page 21).
/ Make sure the rear speaker size parameter is set to
either SMALL or LARGE (see page 19).
Recording cannot be done.
/ Check that the components are connected correctly.
/ Select the source component by rotating the
FUNCTION control.
/ You cannot record the audio signals input to the
5.1CH INPUT jacks.
/ When recording from a digital component, make
sure the input mode is set to ANALOG (see page
25) before recording with a component connected
to the analog MD/DAT or TAPE terminals
(STR-DB930) or the analog MD/TAPE terminals
(STR-DB830).
/ When recording from a digital component, make
sure the input mode is set to DIGITAL (see page
25) before recording with the component
connected to the DIGITAL MD/DAT OUT
terminals (STR-DB930) or the DIGITAL MD/TAPE
OUT terminals (STR-DB830).
Radio stations cannot be tuned in.
/ Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
/ The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
direct tuning.
/ No stations have been preset or the preset stations
have been cleared (when tuning by scanning preset
stations). Preset the stations (see page 44).
/ Press DISPLAY so that the frequency appears in
the display.
RDS does not work.
/ Make sure that you’re tuned to an FM RDS station.
/ Select a stronger FM station.
The station was interrupted by another station
or the receiver automatically starts scanning
stations.
/ The EON function is activated. Turn off the EON
function if you don’t want the current program to
be interrupted.
The RDS information that you want does not
appear.
/ Contact the radio station and find out whether or
not they actually provide the service in question.
If so, the service may be temporarily out of order.
The surround effect cannot be obtained.
/ Make sure the sound field function is on (press
SOUND FIELD – MODE).
/ Make sure that the SPEAKERS selector is set to A
or B (not A+B) if you connected two sets of front
speakers.
/ The sound field effects do not function when the
5.1CH INPUT is selected.
No picture or an unclear picture appears on the
TV screen or monitor.
/ Select the appropriate function on the receiver.
/ Set your TV to the appropriate input mode.
/ Move your TV away from the audio components.
The video image on the TV screen or monitor
does not correspond to the selected component.
/ Check the source of the video signal by pressing
MODE repeatedly to display “V:XXX”. Then rotate
the FUNCTION control to select the appropriate
video source (if necessary).
The remote does not function.
/ Point the remote at the remote sensor g on the
receiver.
/ Remove any obstacles in the path between the
remote and the receiver.
/ Replace all batteries in the remote with new ones,
if they are weak.
/ Make sure you select the correct function on the
remote.
/ If the remote is set to operate the TV only, use the
remote to select a source or component other than
TV before operating the receiver or other
component.
Reference sections for clearing the
receiver’s memory
To clear See
All memorized settings page 17
Customized sound fields page 38