Sony SCEH-00075 Headphones User Manual


  Open as PDF
of 20
 
7. Connecting your headset to Bluetooth® devices
When you turn on your Wireless Headset, it automatically tries to connect to paired devices within range. If
you have paired the headset with more than one device, the headset uses the following priority to determine
which device it will connect to:
1 A PS3™ system that was paired using automatic mode. If the headset finds the PS3™ system within five
seconds, it will stop searching for other devices and connect to the PS3™ system. Further information on
pairing the PS3™ system using automatic mode can be found earlier in this manual.
2 Themostrecentdevice(PS3™systemorotherBluetooth
®-enableddevice)thattheheadsetwas
connected to with which it was paired using Bluetooth® discovery mode. If the headset finds the device
within five seconds, the headset will stop searching for other devices and connect to the device. If the
deviceisnotfound,theheadsetwillcommencesearching(pagescan)mode.
3 Toconnecttheheadsetwiththenextmostrecentdeviceitwasconnectedto,shortpressthepower
button, If that device is found within five seconds, the headset stops searching for devices and makes the
connection.Ifthisdeviceisnotfound,theheadsetgoesintosearching(pagescan)mode.Theusercan
short press the power button every five seconds until it connects to a device from the list of eight most
recently connected devices.
If the headset cannot find any devices to connect to within five minutes after it is turned on, it will turn off
automatically.
8. Testing and configuring the headset
After you have connected the headset to the PS3™ system, you can verify that the PS3™ system is
receiving voice input from the headset and that the headset is correctly playing output.
To test and configure your headset:
On your PS3™ system’s Home Menu, go to [Settings], then [Accessory Settings] and select
[Audio Device Settings].
After you pair a Bluetooth
® device with the PS3™ system, the Bluetooth® device becomes the default for
both input and output audio. If the headset is working correctly, you can hear your voice loop back in the
headset. The audio input bar indicates your voice level.
 previous next