Filter
Top Products
25
Names and Functions of Parts
Chapter 1 Overview
Infrared Remote Commander
The corresponding functions are executed when you point
the remote commander at the infrared sensor of the main
unit and press the keys and setting pad.
If you want to disable control of this unit from the remote
commander, set INTERFACE SELECT >WIRELESS
RMT in the setup menu to “DISABLE” (see page 103).
a Setting pad
Positions on the pad correspond to functions of the main
unit, as follows.
Press the top side: M/MARK1 button
Press the bottom side: m/MARK2 button
Press the left side: </IN button
Press the right side: ,/OUT button
Press the middle: SET button
b THUMBNAIL key
This has the same function as the THUMBNAIL button on
the main unit.
c CHARACTER key
Each press of this key turns the character information
superimposed on the monitor screen on and off, or
switches to the LCD.
d SUB CLIP key
This has the same function as the SUB CLIP button on the
main unit.
Pressing this key has no effect when no clip list is
registered.
e Recording/playback control keys
PREV (previous) key:Press this to jump to the first frame
of the current clip or the previous REC START
essence mark.
1)
When pressed at the first frame of the
current clip, this button jumps to the first frame of the
previous clip (if it exists).
PLAY key: Press this to start playback. Press the STOP
key to stop playback.
NEXT key: Press this to jump to the first frame of the next
clip or to the next REC START essence mark.
1)
STOP key: Press this to stop recording or playback.
1) The setting of OPERATIONAL FUNCTION >FIND MODE determines
whether the unit jumps to clips or to REC START essence marks.
When you play back clips recorded with the Clip Continuous Rec function
(see page 50), you should set this menu item to “REC START EM”.
f SEARCH keys
Press m to perform –5 times normal speed shuttle
playback in the reverse direction.
Press M to perform +5 times normal speed shuttle
playback in the forward direction.
Using the infrared remote commander
Before use
Pull out the insulation sheet.
To replace the lithium battery in the remote
commander
The remote commander uses a CR2025 Lithium Battery.
Do not use a battery other than the CR2025.
1
Hold down the lock lever 1, and then pull out the
battery holder 2.
2
Insert a new battery with the + symbol facing upward
(1), and then push the battery holder until it clicks
(2).
Note
THUMBNAIL
PREV PLAY
SEARCH
NEXT STOP
CHARACTER
SUB CLIP
PUSH SET
1 Setting pad
2 THUMBNAIL key
3 CHARACTER key
4 SUB CLIP key
5 Recording/playback
control keys
6 SEARCH keys
Insulation sheet
1
2