Filter
Top Products
58
Setting the clock to stamp the
recorded time
To stamp the date and time on the MD
when you record, you first need to set the
clock. Once you set the clock, the
recorder will include a time stamp each
time you record something. The recording
date is not recorded for tracks that are
checked out from your computer.
This function can be set with the recorder
only.
1 When the recorder is stopped, enter
the menu and select “OPTION” -
“CLOCK SET”.
The digits of the year flash.
2 Change the current year by turning
the jog dial, and then press the jog
dial.
The digit of the month flashes.
3 Repeat step 2 to enter the current
month, date, hour, and minute.
When you press the jog dial to enter
the minute, the clock starts operating.
If you make a mistake while
setting the clock
Press . to go back to the wrongly
entered item, and then enter the correct
value. You can skip a step by pressing
>.
To display the current time
• On the recorder
While the recorder is stopped or
recording, enter the menu, and select
“DISPLAY” - “Clock”.
• On the remote control
While the recorder is stopped or
recording, press DISPLAY repeatedly.
To display the time in the 24-
hour system
While setting the clock, press T MARK.
To display the time in the 12-hour system,
press T MARK again.
To maintain the correct time
Once you set the clock, it will keep correct time
as long as the recorder is connected to a power
source, such as the charged rechargeable
rechargeable battery, alkaline dry battery, or AC
power adaptor. However, if no power source is
connected, the clock setting will change back to
the factory setting after about 3 minutes.
When changing the alkaline dry battery, make
sure to do it within 3 minutes.
Notes
• Make sure the time is correctly set if you want
the time stamp to be accurately recorded for
an important recording.
• Under normal conditions, the clock may vary
by about plus or minus 3 minutes per month.
Turning off the beep sound
You can turn off/on the beep sound on the
recorder and the remote control.
1 Enter the menu and select “OPTION”
- “BEEP”.
2 Select “BEEP OFF”.
To turn on the beep sound
Select “BEEP ON”.