Filter
Top Products
32-GB
Notes
• The setting will remain even after the power is
turned off.
• If you start recording while the recorder is in
play-pause mode, the recording will begin
from the point at which it is paused even when
the “REC-Posi” is set to “From End”.
Recording from a
microphone
1 Turn the power of the stereo
microphone off, and then connect it to
the MIC (PLUG IN POWER) jack.
The recorder changes to microphone
input automatically.
2 Turn the power of the stereo
microphone on.
3 Press and slide REC to the right.
For other operations, see “Recording
an MD right away! (Synchro-
recording)” (page 18).
Notes
• The recorder automatically switches input in
the following order; optical input, microphone
input, and analog input. You cannot record
through the microphone while an optical cable
is connected to the LINE IN (OPTICAL) jack.
• The microphone may pick up the operating
sound of the recorder itself. Use the
microphone away from the recorder in such
cases. Do not use a microphone with a short
connector, as this may cause the operating
sound of the recorder to be picked up.
• Only left-channel sound is recorded when a
monaural microphone is used.
Adding track marks
automatically (Auto
Time Stamp)
Use this feature to add track marks
automatically at specified intervals when
recording through the analog input
connector or a microphone.
1 While the recorder is recording or in
recording pause, press MENU.
2 Press . or > repeatedly until
“TIME MARK” flashes in the
display, and then press ENTER.
3 Press . or > repeatedly until
the desired time interval flashes in the
display, and then press ENTER.
Select one of the following intervals:
to MIC (PLUG IN POWER)
Stereo
microphone*
REC
∗ See “Optional accessories” (page 76).
Display Time
OFF —
MENU
ENTER/
./>