Filter
Top Products
44
8 Press ENTER.
The type of timer (DAILY 1 or DAILY 2),
followed by the start time, stop time and
the music source, appears, then the
original display appears.
9 Turn off the power.
To check the setting
Press CLOCK/TIMER SELECT and press
. or > repeatedly to select the
respective mode (DAILY 1 or DAILY 2), then
press ENTER on the remote.
To change the setting, start over from step 1.
To cancel the timer operation
Press CLOCK/TIMER SELECT and press
. or > repeatedly to select “TIMER
OFF”, then press ENTER.
Notes
• You cannot activate DAILY 1 and DAILY 2 timer
at the same time.
• You cannot set timer if the timer on and off times
are the same.
• When you use the Sleep Timer, Daily Timer and
Timer recording will not turn on the system until
the Sleep Timer turns it off.
• You cannot activate Daily Timer and Timer
recording at the same time.
Tip
The power turns on 15 seconds before the preset
time.
4 Press . or > repeatedly to
select “DAILY 1 (or 2)”, then press
ENTER.
“ON” appears and the hour digits flash
in the display.
5 Set the time to start playback.
Press . or > repeatedly to set the
hour, then press ENTER.
The minute indication starts flashing.
Press . or > repeatedly on the
remote to set the minute, then press
ENTER.
The hour indication flashes again.
6 Set the time to stop playback
following the above procedure.
7 Press . or > repeatedly until
the music source you want appears.
The indications change as follows:
t TUNER y CD PLAY T
t TAPE PLAY T
Waking up to music (continued)
1
1