Filter
Top Products
35
Recording a CD by
specifying track order
— Program Edit
You can record tracks from all the CDs in the
order you want. When programming, make
sure the playing times for each side do not
exceed the length of one side of the tape.
1 Place a CD and insert a recordable
tape into deck B
2 Press CD.
3 Press PLAY MODE repeatedly until
“PROGRAM” scrolls and “PGM”
appears in the display.
4 Press one of the DISC 1~3 buttons to
select a CD.
To program all the tracks on a CD at
once, proceed to step 6 while “AL”
appears in the display.
5 Press . or > until the track
you want appears in the display.
6 Press ENTER.
The track(s) is(are) programmed. The
program step number appears, followed
by the total playing time.
7 To program additional tracks to be
recorded on side A, repeat steps 4 to
6.
Skip step 4 to select tracks from the same
disc.
8 Press X to insert a pause at the end
of side A.
“P” appears in the display and the total
playing time resets to “0.00” in the
display.
Disc tray
number
Track number
Total playing time
(including selected track)
?/1
(Power)
continued
3
x
1
8
6
11
5
24
EDIT
510 12
1
DOLBY NR
NXx
xMm>.
nN
O
X
CHECK
EDIT
PGM