Filter
Top Products
25
Other Features
To
Check the remaining
time
(Except for AUTO)
Change the time to
turn off
Cancel the Sleep
Timer
Waking up to music
— Daily Timer
You can wake up to music at a preset time
every day. Make sure you have set the clock
(see “Setting the time” on page 11).
1 Prepare the music source you want to
play.
• CD: Load a CD. To start from a specific
track, make a program (see
“Programming the CD tracks” on page
13).
• Tape: Load a tape with the side you
want to play facing forward.
• Radio: Tune in the preset station you
want (see “Listening to the radio” on
page 15).
2 Adjust the volume.
3 Press CLOCK/TIMER SET.
“DAILY1 SET” appears.
4 Press . or > repeatedly to select
“DAILY1 SET (or DAILY2 SET)”, then
press ENTER.
“ON” appears and the hour indication
flashes.
5 Set the time to start playback.
Press . or > repeatedly to set the
hour, then press ENTER.
The minute indication flashes.
Press . or > repeatedly to set the
minutes, then press ENTER.
The hour indication flashes again.
6 Set the time to stop playback following
step 5.
7 Press . or > repeatedly until the
music source you want appears.
The indications change as follows:
t TUNER y CD PLAY T
t TAPE PLAY T
8 Press ENTER.
The type of timer (“DAILY 1” or “DAILY
2”), followed by the start time, stop time
and the music source, appears, then the
original display appears.
9 Turn off the power.
To
Check the setting
Change the setting
Cancel the Daily
Timer
Tip
You can use the digipad instead of ./>.
Notes
• If the power is on at the preset time, the Daily
Timer does not work.
• When you use the Sleep Timer, the Daily Timer
will not turn on the system until the Sleep Timer
turns it off.
• The power turns on 15 seconds before the preset
time.
Press
SLEEP once.
SLEEP repeatedly to select
the time you want.
SLEEP repeatedly until
“SLEEP OFF” appears.
Do this
Press TIMER SELECT and
press . or > repeatedly
to select the respective mode
(“DAILY 1” or “DAILY 2”),
then press ENTER.
Start over from step 1.
Press TIMER SELECT and
press . or > repeatedly
to select “TIMER OFF”, then
press ENTER.